 |
| Puzzle joints before gluing |
I took the weights off the planks and the board I had screwed to the table. The joints on the planks looked good but the big puzzle joint on the bottom piece came out wrong. The puzzle pieces were not flat, even though this is the one I was able to screw down. I looked at the CLC web site but did not see a solution. I don't know whether to add more epoxy or sand the plywood down to make the joint flat. I laid out planks 3 and 4 and glued them together and put the weight on them. Because if the warning in the manual, I was careful to put a piece of plastic on top of the joints before I added the weight. I didn't want a 2x8 stuck to the dory plank.
No comments:
Post a Comment